Coolertech refurbishment services

Restore the surfaces.
Protect the asset.

Corrosion can affect both HVAC equipment and the steel that supports it. Coolertech provides surface preparation, localized repairs, and protective coatings to help extend the useful life of existing assets.

See before & after ↓Request an assessment →

Finished rooftop HVAC equipment support refurbishment

What we refurbish

From equipment interiors to supporting steel.

We develop the work scope around the condition of the asset, site access, and the surfaces that need attention.

Air handlers and packaged units

Refurbishment of deteriorated metal surfaces within commercial HVAC equipment.

Cabinet floors, walls, and roofs
Drain pans and filter racks
Outside-air intake sections

Equipment supports and steel

Surface restoration and corrosion protection for steel exposed to outdoor conditions.

I-beams and support frames
Equipment bases and platforms
Accessible brackets and connections

Fans and mechanical sections

Repair and coating scopes for exposed mechanical equipment surfaces.

Fan housings and blower sections
Metal panels and mounting frames
Localized sheet-metal repairs

Featured refurbishment

Rooftop equipment supports.
Before and after.

These project photos show the original corrosion and coating deterioration, followed by the finished gray-coated support framing. Views are grouped by project stage and may show different angles.

**Before**Rooftop equipment and support frame

**After**Finished equipment support frame

**Before**Corrosion along the equipment support

**After**Finished support beneath the coil section

**Before**Original beam surfaces and coating condition

**Before**Localized corrosion on a steel member

**Before**Original support framing and connections

**After**Finished framing around rooftop equipment

More refurbishment work

Steel supports.
Condition, preparation, and finish.

A closer look at corrosion around beams and connections, work on the steel surfaces, and the finished coating. Photos are grouped by project stage; viewing angles vary.

**After**Finished beam connections and supports

**Before**Original beam surface beneath equipment

**After**Finished beam surface beneath equipment

**Before**Original equipment support framing

**After**Refurbished framing beneath the equipment

**Before**Corrosion along an equipment support beam

**After**Finished support beam and equipment mounts

**Surface preparation**Exposed steel surface during refurbishment

**Coating stage**Coating work on the beam surface

Our process

A defined scope, from assessment to finish.

01 · Assess

Review the condition

Document the affected surfaces, access requirements, and areas needing repair. Coordinate work around equipment operation and site needs.

02 · Prepare

Prepare the surfaces

Remove loose coatings, corrosion, and contaminants using preparation methods specified for the substrate and selected coating system.

03 · Restore

Repair and protect

Complete the agreed localized repairs and apply the specified protective coating system. Repair and coating selections depend on the assessment.

04 · Document

Review the finished work

Provide completion photos and project-specific maintenance information. Inspection and warranty options are defined in the proposal.

Plan around your facility

Clear scope. Practical scheduling.

We discuss containment, access, equipment downtime, surface preparation, and coating requirements before work begins. Where section loss or structural damage is identified, the repair scope must account for the required structural evaluation.

The Forum · Pompano Beach